Back to Home Page of CD3WD Project or Back to list of CD3WD Publications

CLOSE THIS BOOKWorking on Grinding Machines (Institut für Berufliche Entwicklung, 10 p.)
VIEW THE DOCUMENT(introduction...)
VIEW THE DOCUMENT1. The Purpose of Grinding on a Belt Grinding Machine
VIEW THE DOCUMENT2. Construction of a Belt Grinding Machine
VIEW THE DOCUMENT3. The Grinding Tools
VIEW THE DOCUMENT4. The Operation of a Belt Grinding Machine
5. The Technological Processes of Grinding

4. The Operation of a Belt Grinding Machine

The sand belt is put into straight-lined motion by the motor over the belt roller.

The sand belt is pressed on the piece of work by the pressure shoe. Thereby the abrasive grains remove very fine shavings in form of abrasive dust from the piece of work. Because of the movability of the grinding table and the pressure shoe all parts of the surface of the piece of work are reachable.


Figure 3

1 sand belt with indication of running direction, 2 machine table, 3 piece of work, 4 hand grip on the machine table, 5 ball grip on the pressure shoe

TO PREVIOUS SECTION OF BOOK TO NEXT SECTION OF BOOK

CD3WD Project Donate